
|
Waterways |
||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
Ecoboard Specifications
|
||
![]() |
||
Decking & Bulk Heading
Fasteners
Decking
- Stainless Steel Square Head
# 10 decking screws are highly recommended.
- Pre-drilling is required on all Decking boards if screws are not self-tapping.
- All fasteners should be placed no closer than 1” from any edge nor protrude
from any board closer than 1” form any edge.
Bulk Heading - Pre-Drilling is required when using 40 or 60 penny nails. Whaler spacing should be 36” or less for 2” x 10” and 60” or less for 3” x 10” boards.
Design Considerations
Board Spacing - ECOBOARD® will expand and contract linearly approximately .000064/in./in./deg. F. this can be calculated by board size as shown by the following examples:
5/4 x 6 x 12’ =
approximately 1/4” over a 30°F change in temperature.
2 x 6 x 12’ = approximately 1/3” over a 30°F change in temperature.
When installing in temperatures over 45°F butt all ends as closely as possible. Spacing between boards is at the discretion of the consumer.
Before starting any building project be sure to check with the proper governing agencies or Associations for any approvals, permits or covenants that may apply to your home.
Spans - Decking -Suggested decking span is 16” on center for both the 5/4” and 2”x 6” boards for the designs shown below. Call for technical evaluation on alternative designs.
Railings
- Posts for railings should be no more than 4 feet apart and tag bolted to the
fascia beam or joist - Do Not Notch Posts! Snow rail designs must be
supported every 2 feet with blocker piece to avoid possible sagging. See design
criteria on following pages.
Contact us if you have question or would like
samples of our products.
The PLL Company
12550 E. Carson St. #20, Hawaiian Gardens, CA 90716
Voice: 310-320-1945 or 562-420-2824 Fax:310-320-1945
Website:
www.thepllcompany.com E-mail:
thepllcompany@earthlink.net